Cumberland CC2415, Инструкция по установке и эксплуатации

Страница: 8 / 34

8 PNEG-620-2 Curtain Controller
3. Installation
This manual outlines the recommended sequence for the installation of the Curtain Controller system.
The curtain controller may be installed either inside or outside. Following the sequence will prove the
safest and easiest method of installation. Above all, connection of the system to the electrical mains
should be the final stage of installation. Failure to observe this could lead to a fatal accident.
1. Unpack the Curtain Controller, remove the front cover and inspect the machine for visible defects.
2. Select mounting configuration. (See examples of: wall mount on Pages 25-27 .)
3. Screw one 3/8" x 3" lag bolt 6-1/2" below the desired height of the Curtain Controller.
NOTE: Leave 1-1/2" between the bolt head and the wall. (See Figure 3A.)
Figure 3A
4. Using the “keyhole” slot in the back of the Curtain Controller, hang the machine on the 3" lag bolt.
(See Figure 3B.) NOTE: The 3" lag bolt should only be used to hang the machine to the wall.
Do not attempt to operate the machine until it is fully secured.
Figure 3B