Cumberland 48 INCH MEGA-FLOW CONE FAN, Руководство по установке

Страница: 7 / 10

Cumberland .

1004 E. Illinois St.

Assumption, IL 62510

PHONE 1-217-226-4421

FAX 1-217-226-4420
Manual Part No. 4801-5350 Rev 1-15 Page 7 of 10
7. Carefully lift the attached panels and wrap panels
into cone shape as shown in
Figure 5 . Attach
final corner bracket with 1/4" bolts and nuts to
fasten cone together. The assembled cone with
corner brackets should now appear as in
Figure 5 .
8. Disconnect all electrical power from fan.
9. Carefully lift and support cone assembly. Fit cone
into position over outside of fan orifice on exhaust
side of fan. At this point, tighten bolts and nuts as
required to achieve a tight fit of cone around
orifice.
10. While supporting cone assembly, attach a top
corner bracket to fan housing. Position bracket,
install 1" TEK screws into fan housing through
holes in bracket.
See Figure 6.
11. Repeat Step 10 to attach corner bracket to
opposite corner of fan housing. Cone assembly
should now hang in place.
12. Attach two remaining corner brackets of cone to
fan housing with 1" TEK screws.
13. Install wire guard (supplied) to cone. Align wire
guard with four mounting holes in cone. Install
cap screws, washers and nuts to guard.
14. Reconnect power to fan.
15. Cone installation complete.
Attach corner
bracket with
TEK screws.
Figure 6:
Attach Bracket to Fan
Install wire guard with 90

bend pointed toward
inside of cone.
Wire guard
Final Step
Tighten
Bolts
Figure 5: Install Guard to Cone