Cumberland 48 INCH MEGA-FLOW CONE FAN, Руководство по установке

Страница: 5 / 10

Cumberland .

1004 E. Illinois St.

Assumption, IL 62510

PHONE 1-217-226-4421

FAX 1-217-226-4420
Manual Part No. 4801-5350 Rev 1-15 Page 5 of 10
C O N E I N S T A L L A T I O N
4 8

Packing List For One (1) Cone Kit Tools Required
Four (4) Cone Sections Four (4) Corner Brackets
7/16 in. (11 mm) Wrench Ratchet
One (1) Wire Guard Five (5) 3/8"-16 x 1 Cap Screws
Sixteen (16) ¼-20 Nuts Ten (10) 3/8" Washers
7/16 in. (11 mm) Socket
Marker or Scribe
Sixteen (16) ¼-20 x 3/4 Bolts Five (5) 3/8"-16 Nuts
Sixteen (16) #14 x 1” TEK Screws
Cordless drill and bit
(For Installing TEK screws)
WARNING!
During Cone Installation Be Sure That Fan Motor Is Not Plugged Into Any Power Source.
Always Double Check Power Sources.
1. Lay cone pieces flat with their flanges pointed up.
Refer to Figure 1.
2. For each panel, bend tabs upward in same direction
as flange.
NOTE: Bend tabs by hand. See Inset Figure 1.
3. Arrange panels with flanges and tabs contacting as
shown in
Figure 1. Align holes of flanges and
tabs.
Assembly and Installation of Cone 48

Outs
ide E
dge
Insid
e Ed
ge
Arrange panels for assembly
with flat sides down, flange
sides up. The bent tabs of
one panel should contact the
flange of adjacent panel.
Tab before
bending
Bend tab upward
Flange
Tabs
Joints
Mounting
Hole For
Wire guard
Figure 1:
Cone Assembly
!