P
A
R
T
T
R
E
H
E
15
P
A
R
T
E
E
T
H
R
14
Note
. If the home position is not detected within 10 minutes, the main display will show
an Err 1 message to indicate a controller error and an audible alarm will sound. The
error condition can only be cleared by removing and re-applying the power.
IF PROBLEM PERSISTS, PLEASE CALL YOUR WATERSIDE DEALER OR
CONTACT OUR TECHNICAL HELP DESK ON 01376 334200
CHECKLIST
SOLUTION
Page
Section
PROBLEM: NO WATER
Is the mains stop valve
open?
Open the mains stop valve.
9
9
Are the inlet and outlet
valves of the water softener
open?
Open the inlet and outlet valves to
the water softener.
9
9
PROBLEM: WATER RUNS FROM THE DRAIN CONSTANTLY
Is the unit in recharge
mode?
If yes, this is normal, wait until the
recharge is complete.
3
There should be no flow to drain in
the service position. Isolate the
softener and call for service.
9
9
PROBLEM: EXCESSIVE SALT USAGE
Check the hardness
setting.
Reduce the hardness if incorrect.
9
8
PROBLEM: ELECTRONIC DISPLAY
The display shows error
code "Err 1", audible alarm
sounds, (see note below).
Check all the connections are
secure. Turn the power off for 10
seconds then turn back on, allow
the system to reset.
8
5
The display shows error
code "SALt", audible alarm
sounds.
The low salt alarm is active. Fill the
brine cabinet with salt. Pressing the
SET key will reset the salt alarm to
full capacity of salt.
8
6
Is the digital display blank? Check the power is turned on and
all the connections are secure.
8
5
PROBLEM: UNIT REGENERATES AT THE WRONG TIME
Is the present time correct? Reset the present time.
10
3
Notes
* Flow rates are from 10 and up to a peak of 50 litres / min. At flow rates under 10 litres /
min the hardness may not be effectively removed from the water. If peak flow rates are
sustained for longer than 10 minutes the softener capacity may be reduced resulting in
hard water breakthrough.
**The proportional brining control system calculates the exact amount of water and salt
required to regenerate the water softener. The amounts used will vary depending on water
usage patterns.
SPECIFICATION TABLE
MC450
MC550
50
50
30
35
24
28
10
10
1.4
2.2
5
5
1.7
1.7
49
49
5
5
230
230
12
12
3/4"
3/4"
1/2"
1/2"
Model
Maximum peak flow rate L/min*
Maximum continious flow rate L/min
Basic flow rate (flow @ 1 bar pressure loss)
Minimum flow rate L/min*
Salt usage per regeneration Kg**
Maximum pressure (bar)
Minimum pressure (bar)
Maximum water temperature
Minimum water temperature
Primary voltage a.c. (transformer)
Secondary voltage d.c. (controller)
Inlet / outlet connections (BSP)
Drain connection (tube)
12
15
13
19
80
90
532
602
270
270
480
480
18
22
40
50
Salt storage Kg (tablet models only)
People days
Maximum water used per regeneration Litres**
Height mm
Width mm
Depth mm
Unit Weight Kg (empty)
Unit weight Kg (in service)
