2 YEAR WARRANTY
All claims for parts or labor must be made directly through Culitek. All claims must include model number of
the unit, the serial number, proof of purchase, date of installation, and all pertinent information supporting the
alleged defect. In case of compressor replacement under warranty, either compressor or compressor tag must be
returned to Culitek along with above listed information.
Failure to comply with warranty policies will result
in voiding claims.
Two Year Parts & Labor Warranty
Culitek warrants all new refrigerated components, such as the cabinet and all parts, to be free from defects in
materials or workmanship. Culitekʼs obligation under this warranty is limited to a period of two (2) years from
the date of shipment from Culitek. All parts covered under this warranty that are defective within two (2) years
from the date of shipment from Culitek are limited to repair or replacement (including labor charges) of
defective parts or assemblies. The labor warranty shall include standard straight time labor charges only and
reasonable travel time, as determined by Culitek.
Additional Three-Year Compressor Warranty
In addition to the two (2) year warranty stated above, Culitek warrants its sealed compressor to be free from
defects in both material and workmanship under normal and proper use and maintenance service for a period of
three (3) additional years from the date of original installation, but not to exceed five (5) years. Compressors
that have been determined to be defective from Culitek within this extended period will be either repaired or
replaced with a compressor or compressor parts of similar design and capacity according to Culitek’s discretion.
The three (3) year extended compressor warranty applies only to sealed parts of the compressor and does not
apply to any other parts or components. This includes, the cabinet, paint finish, temperature control, refrigerant,
metering device, motor starting equipment, fan assembly, and other electrical components, etc.
Compressor Warranty
The five-year compressor warranty detailed above will be void if the following procedure is not carefully
adhered to:
1. This system contains R404A, R134a, or R290 refrigerant and lubricant. The lubricant has rapid moisture
absorbing qualities.
2. Drier replacement is very important and must be changed when a system is opened for servicing.
3. Micron level vacuums must be achieved to insure low moisture levels in the system.
4. Compressor must be obtained through Culitek, unless otherwise specified in writing, through Culitek’s
warranty department.
