CULITEK F1SS, Инструкция пользователя

Страница: 9 / 15

Page 8
14. Operating Instructions
1. New upright air-cooling unit should be opened and ventilated before it is used.
After that, users should use warm water to clean its inside.
2. After connecting the power supply, press the "POWER" switch on the
controller keyboard (Green Indicator Light ON), the fridge will turn on.
The microcomputer controller, installed in the controller keyboard,
can automatically adjust the temperature ranges. This intelligent
digital controller works by recognizing when the temperature
increases and reaches set point, plus differential when the compressor
is started and turns off when the temperature reaches the set point value again.\
3. Microcomputer Controller Operation Instruction:
4. Microcomputer panel sketch map, meanings of running indicator light and LED showing.
5. Display target set point. In programming mode,
it selects a parameter or confirms an operation.
Start a manual defrost.
In programming mode, it browses the parameter codes,
or increases the displayed value.
In programming mode, it browses the parameter codes,
or decreases the displayed value.
Lock or unlock keyboard.
To enter in programming mode.
To return to room temperature display.
6. How to see the point:
Push and immediately release key, the point will be displayed;
Push and immediately release key, or wait 5 seconds to return to normal visualization.
7. How to change the point:
To change point value, push the key for more than 2 seconds;
the value of the point will be displayed and the
°
F
or
°
C
LED will start blinking.
To change value, push the or arrows.
To memorize the new point value, push the key again, or wait 10 seconds.
8. How to start a manual defrost:
Push key for more than 2 seconds, and a manual defrost will start.
9. How to change a parameter value:
Enter programming mode by pressing and keys;
°
F or
°
C LED starts blinking.
Select the required parameter. Press to display its value.
Use or to change its value.
Press to store the new value and move to the following parameter.
To exit press or wait 15 seconds without pressing a key.
NOTE: The value is stored even when exiting the procedure by waiting for the time-out to expire.
AUX
+
+
+
AUX
AUX
AUX