4
PARTS
1. Lid with Removable Filler Cap
2. Pitcher
3. Silicone Washer
4. Blade Attachment Section
5. Motor Drive Coupling
6. Base / Motor
7. 10-Speed Control Panel
ASSEMBLING BLENDER
CAUTION: To avoid damage to Blender or serious personal injury:
DO NOT
operate or plug Blender into electrical outlet until Blender is completely assembled.
Blades are very sharp, handle with utmost care.
DO NOT let children touch Blades
.
1.
Ensure Blender is unplugged from electrical outlet.
2.
Place Base on a flat, level & stable surface.
3.
Wash Pitcher in hot soapy water and dry.
4.
Ensure Silicone Washer is fully in place around base of Blade Attachment Section just
above locking tabs.
5.
Insert Blade Attachment Section into bottom of Pitcher and turn clockwise (as indicated
by arrows on bottom of Blade Attachment Section) until locking tabs of Blade Attachment
Section have fully locked into place with bottom of Pitcher.
6.
Place Pitcher onto Base making sure Motor Drive
Coupling and fittings located on top of the Base/Motor
are aligned.
7.
Twist Pitcher counterclockwise until locking tabs of
Base and Pitcher have fully locked into place and
arrows on Base and Pitcher are aligned.
NOTE
: To lock Pitcher to Base, place Base with
10-Speed Control Panel facing you. Locate arrow at
the top left of the Base under locking tab. With Pitcher
handle facing on the right side of the Base, twist
Pitcher counterclockwise to align Base arrow with
arrow located on left bottom side of Pitcher, across the
side from the Handle.
8.
Place Lid on top of Pitcher and secure it into position.
NOTE
: Pitcher handle has a slide release mechanism to hold Lid to Pitcher. Make sure Lid is
always securely in place on top of Pitcher before operating Blender.
