17
•
Allow only qualifi ed licensed LP gas dealers to properly fi ll or repair your LP gas cylinder.
•
New tanks should be purged prior to fi lling; inform LP gas dealer if you are using a new tank.
•
DO NOT allow the cylinder to be fi lled beyond 80% capacity. Over-fi lled tanks can create a
dangerous condition. Over-fi lled tanks can build-up pressure and cause the relief valve to expel
propane gas vapors. The vapor is combustible and if it comes in contact with a spark source or
fl ame an explosion causing severe burns, bodily harm, or death could occur.
• Always
use a protective cylinder cap when grill is not connected to cylinder.
•
If you exchange a cylinder with a qualifi ed exchange program, the new cylinder must have
a Type 1 valve and an over-fi lling prevention device (OPD).
•
Inspect the propane tank valve rubber seal for cracks, wear or deterioration prior to use. A
damaged rubber seal can cause a gas leak, possibly resulting in an explosion, fi re or severe
bodily harm.
FILLING THE LP GAS CYLINDER (TANK):
WARNING
LP GAS CYLINDER (TANK) SPECIFICATIONS:
LP gas cylinder (not supplied with this grill)
The LP (Liquid Propane) gas cylinder specifi cally designed to be used with this grill must be 12” (30.5 cm)
diameter x 18” (45.7 cm) tall and have a 20 lb. (9.1 kg) capacity incorporating a Type 1 cylinder valve and
an over-fi lling protection device (OPD).
This grill is designed to fi t Worthington, Manchester or SMPC brand 20 lb. (9.1 kg) cylinders. Other brand
DOT cylinders may fi t this grill if the cylinder has similar dimensions of the top and bottom rings.
The installation of this appliance must be in accordance with:
All applicable local codes, or in the absence of local codes, either:
•
National Fuel Gas Code ANSI Z223.1 NFPA 54
To check your local codes, see your local LP gas dealer or natural gas company. This grill was not
intended to be connected to a natural gas supply line.
When purchasing or exchanging a cylinder for your gas grill, it must be constructed and marked in
accordance with the specifi cations for LP gas cylinders of the U.S. Department of Transportation (DOT)
or the National Standard of Canada, CAN/CSA-B339 Cylinders, Spheres and Tubes for Transportation of
Dangerous Goods; and Commission, as applicable; and provided with a listed over-fi lling prevention device
(OPD), and provided with a cylinder connection device compatible with the connection for outdoor cooking
appliances.
The cylinder must also be equipped with:
•
A shut-off valve terminating in a Type 1 gas cylinder valve outlet.
•
A Type 1 valve that prevents gas fl ow until a positive seal is obtained.
•
An arrangement for vapor withdrawal.
•
A collar to protect the cylinder shut-off valve.
•
A safety relief device having direct communication with the vapor space of the cylinder.
•
A listed over-fi lling prevention device (OPD).
