6
TROUBLESHOOTING
Symptom
Possible Cause
Solution
On/Off Power
button does not
light up.
Unit might not be plugged
into outlet.
Check the wall outlet for power. Make
sure the outlet is not controlled by a wall
switch.
It takes longer than
45 minutes for
the water to pass
through the fi lter.
Some air is still in the fi lter.
Place fi lter in an
empty
bowl, then fi ll with
water, making sure it is
fully
submerged.
Resoak it for 10-15 minutes, or until no
more bubbles are observed.
Unit does not
dispense water
when buttons are
pushed.
Internal
water tank is not
completely fi lled with water.
Review “Filling the Internal Tanks” on page 5
to be sure it was done correctly. Make sure the
lower water tank is full. Continue to press and
hold push buttons until water flows is steady. If
unit still won’t dispense water or flow does not
become steady, contact Customer Service.
Water continues
fl owing from spigot
after push button is
released.
Push button is stuck.
Remove water tanks from the base.
Continue pressing button until it no longer
sticks.
HOT water LED
does not light up.
1. Power is not on.
2. There is no water in
tanks.
1. Make sure unit is plugged into outlet.
2. Make sure air has been purged from
internal tanks, as stated on page 5.
3. If there is water in the tanks, it will take
about 10 minutes for the water to heat.
COLD water LED
does not light up.
1. Power is not on.
2. There is no water in
tanks.
1. Make sure unit is plugged into outlet.
2. Make sure air has been purged from
internal tanks, as stated on page 5.
3. If there is water in the tanks, it will take
about 80 minutes for the water to chill
the fi rst time. It takes only about 30
minutes for subsequent fi ll-ups.
Filter Timer does
not show “Filtering”
or “Replace.”
Battery is dead.
Contact Customer Service for replacement
fi lter timer.
Leakage on the
countertop.
1. Water tanks are not
properly seated on base.
2. Drainage plugs are not
fully engaged.
1. Make sure water tanks are seated
properly on the base.
2. Ensure that drainage plugs are correctly
installed on the bottom of the base.
Water leaks from
the top cover.
Water tanks are overfi lled.
Drain excess water from tanks by pressing
push buttons.
ROOM temperature
water is warm.
HOT and ROOM temperature water must
be used on a regular basis.
IB-7514D(0.0).indd Sec1:6
IB-7514D(0.0).indd Sec1:6
8/16/08 3:29:14 PM
8/16/08 3:29:14 PM
