4
m
SAFETY INFORMATION
The Fuel System
Gas grills are used safely by millions of people when following simple safety precautions.
The items in the fuel system are designed for operation with this grill. They must not be replaced with any
other brand. (See parts list for replacement items.)
GAS BURNER: The gas burner is constructed of stainless steel and should not require maintenance other
than inspection for insects/nests inside the air intake slots.
FUEL SUPPLY HOSE: The hose connected regulator provided with this appliance is 38 inches length. Keep
the fuel hose away from any heated surface(s).
PROPANE FUEL: Warning - propane is a flammable gas. Improper handling may result in an explosion and/or
fire and serious accident or injury. Your grill is designed to operate with propane (LP) gas only and is equipped
with the proper orifice for propane gas.
Caution: Do not connect this grill with any gas supply other than propane. Propane gas is heavier than air
and settles in lower areas. Make certain adequate ventilation is available when using your grill. The gas cylinder
may be stored outside in a well-ventilated area out of the reach of children when the grill is not in use. If the
appliance is not in use, the gas must be turned off at the supply cylinder.
The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or
any other enclosed area. The Portable Gas Grill may be stored indoor if the LP gas cylinder is removed and
stored outdoor. The LP gas cylinder (not included) is threaded for connection directly to the gas regulator sup-
plied with this appliance. Care should be taken when threading the cylinder to the regulator to engage threads
correctly to achieve the proper and intended connection. When disconnecting or connecting the gas cylinder,
be careful that the regulator does not strike the grill, the ground, or any other surfaces. Replace the protective
cap over the threaded cylinder connection when removed from grill. If any difficulty occurs when connecting
or disconnecting the cylinder to the regulator assembly, contact your local gas supplier for assistance.
When re-connecting the LP gas cylinder to the regulator, be sure to hand-tighten until snug. This connection
should be inspected for damage and leak tested after each re-connection.
To Leak Test, make a soap solution of one part liquid detergent and one part water. You will need a spray
bottle, brush, or rag to apply the solution to the fitting. Bubbles indicate leaks.
Regulator
Propane
cylinder
Check all gas supply fittings for leaks before each
use. Do not use the grill until all connections have
been checked and do not leak.
