Cuckoo CP-FR601SW Series, Руководство пользователя

Страница: 13 / 32

13
How to Install the Product
❺
Connect the sink feed line to T-Valve:
- Connect the nut (from the sink faucet feed line) to the open end of the T-Valve and tighten. Make
sure the connection between the T-Valve and sink feed line is secure.
❻
Connect ¼” Water Line:
- Locate the "tap water inlet" on the water filtration unit and insert the 1/4" tubing (from install kit),
connect the other end of the 1/4" tubing to the T-Valve quick connect connection. Make sure both
connections are secure.
❼
Reverse Osmosis Drain Line and Saddle Valve:
- Reverse osmosis filters require a drain line be connected from the RO membrane to a drain pipe.
Locate a horizontal or vertical section of drain pipe (wastewater from the sink) under the sink
before the p-trap and away from the garbage disposal. The saddle valve is installed to hold this
drain line connection firmly onto the drain pipe.
❽
Saddle Valve:
- Place the saddle valve (from install kit) in the selected location of drain pipe. Mark the area where the saddle
valve has its 1/4" opening on the drain pipe.
❾
Drill Drain Line:
- Drill a 1/4" hole through the marked area that represented the opening of the saddle valve. Only
drill through one side of the drain pipe, do NOT drill all the way through the other side of pipe.
❿
Line up Saddle Valve:
- Arrange the saddle valve onto the drain pipe so that the 1/4" hole you drilled matches up with the
1/4" hole in the saddle valve. Use a bit of the water line tubing or a drill bit to ensure the holes are
aligned.
Secure Saddle Valve:
- With the holes still aligned, secure the saddle valve clamps in place. Make sure the hole are still aligned before
tightly securing the saddle valve nuts.
Connect Drain Line:
- Secure the second ¼” water line in the saddle valve opening (to the drain line) on one end, to the
external output of the water cooler on the other end. Make sure the connections are secure. The drain
line (from water unit) should be fully into the drain pipe and secure.
Double check all connections:
- Check all water line connections to ensure they are secure
Turn on Cold water:
- Reopen the cold water inlet valve by turning counter clockwise. This will allow water flow through
the attached water line, into filters and to the water unit. CHECK THERE ARE NO LEAKS
Flush Filters:
- Allow the water tanks to fill completely and empty the contents to flush the unit. Complete this
process twice. The water level indicators will illuminate brightly when tank is full.
Turn on Hot/Cold Function
- After flushing the filters and unit, allow the hot and cold water tanks to fill completely. Once full,
you may turn on the hot and cold buttons on the unit to heat and cool the purified water.
*It is very important to allow the tanks to fill completely before turning the hot/cold on.