Cubicon Single Operation Manual
(150616,En)
Copyright Reserved HyVISION System Inc. 18 / 44
This document is a general purpose operation manual and is subject to change without notice when necessary
for product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
6.2. LCD Display of Status
When Cubicon Single is turned on or when the menu is not activated for functional setting, the current
printer status is shown on the LCD display.
[1] Extruder nozzle temperature
Current temperature / Target temperature
[2] Heating bed temperature
Current temperature / Target temperature
[3] Printer inside temperature
Current temperature / Target temperature
[4] Molding fan rotating speed
Rotating speed of the molding fan (max. 100%)
[5] File for output
Name of the output file in the SD card (in English)
[6] Printer operation status
Current printer operation status. If the printer is currently printing, the current
printing time (hh:mm) and progress rate are displayed.
* The extruder nozzle and heating bed are heated or cooled to achieve the target temperature.
* The printer’s internal temperature rises with the heat from the nozzle and heating bed when the printing
begins. Once the current temperature reaches the target temperature, the outside air is circulated to cool the
printer. To ensure safety, this product does not use a separate heater to increase the current temperature.
* The noise from the ventilation fan is generated when the convection circulation function is activated to
lower the inside temperature.
* The unit of te
mperature is “
℃
“.
* When the printing is paused, the file name and printing time are displayed on [5].
* The details of the LCD display may be different according to the firmware version.
* The extruder nozzle and heating bed are heated or cooled to achieve the target temperature.
* The printer’s internal temperature rises with the heat from the nozzle and heating bed when the printing
begins. Once the current temperature reaches the target temperature, the outside air is circulated to cool the
printer. To ensure safety, this product does not use a separate heater to increase the current temperature.
* The noise from the ventilation fan is generated when the convection circulation function is activated to
lower the inside temperature.
* For the filament, the target temperatures (heated temperatures) of the [1] extruder and [2] heating bed are
very important.
[1] If the extruder nozzle temperature is too far above or below the filament melting temperature, extrusion
quality can be poor, and an extruder malfunction may result.
The recommended filament melting temperature ([1]Extruder target temperature) is printed on the sticker of
the filament spool. Make sure that the printer is maintained at the proper temperature, by referring to the
target temperature.
[2] The heating bed temperature also differs according to the type of filament used. The recommended
heating bed temperature for Cubicon Single is
60~70 for PLA and 110~120 for ABS.
However, as the actual
temperature may differ according to the printed object, use the proper temperature accordingly. If the
heating bed temperature is not suitable for the filament being used, the printed object may not adhere to
the heating bed or the bottom output status may be defective.
Cubicon Single’s heating bed is designed to ensure that the printed object is adhered to the heating bed
when printing at a specific temperature or higher in the case of PLA/ABS filament even without the
Kapton tape, as well as to ensure that the printed object is easily removed from the bed when the
temperature drops.
1
3
5
6
2
4
