A
Fig.6
Trace the cable from the LED light strip
(Fig5: B)
which
exits from the removable cover at the centre of the rear
diffuser plate. Connect the end of this cable to its respec-
tive partner which can be found exiting the electrical
distribution box. Ensure that the threaded coupling is
firmly connected and tightened to ensure a water tight
seal. Should the LED light strip require replacement at
any time, this can easily be done by removing the
protective top cover on the light strip channel
(Fig5: A)
and sliding the old strip out prior to replacement with a
new unit.
LED LIGHT STRIP
If using a chiller or remote power filter, unscrew the two blanking plug flanges
from the inlet and outlet pipework on the outside of the rear panel
(Fig6:a)
and
connect using the supplied male and female hose tails. If hard-plumbing the
aquarium, the blanking plugs may be cut, leaving enough pipe left over to allow
bonding to other fittings. IMPORTANT: Always use inline taps between the
aquarium and any external equipment so that water lines may be closed in the
event of a leak. If not using any kind of external device, ensure both blanking
plugs are tightened gently by hand prior to filling the aquarium.
Fig.5
A
B
A
A
Fig.4B
Fig.4A
ADDING AN EXTERNAL
FILTER OR CHILLER
FILTER SPONGE
The aquarium comes with 2 x carbon impregnated filter sponges
(Fig 4A)
. Ensure that both sponges are seated
correctly into their respective guides on either side of the rear perforated diffuser plate
(Fig 4B)
. The sponges will help
trap any waste or uneaten food, and will help disperse the suction of water through the rear diffuser plate over a wide
area to ensure no livestock becomes trapped against the diffuser plate.
page
4
Содержание casja80l
Страница 1: ......
