Cub Cadet Z-Force Pro, Руководство оператора

Страница: 16 / 28

Service
4
16
Lubrication
WARNING! Before lubricating,
repairing, or inspecting, always
disengage PTO, set parking brake,
stop engine and remove key to
prevent unintended starting.
Pivot Points & Linkage
Lubricate all the pivot points on the drive
system, parking brake and lift linkage at least
once a season with light oil.
Front Wheels
Each of the front wheel axles and rims is
equipped with grease fittings (a). See Cleaning &
Lubricating the Spindle Pulleys. Lubricate with a
No. 2 multi-purpose grease applied with a grease
gun after every 25 hours of tractor operation.
(a)
Figure 4-2
Cleaning & Lubricating the Spindle Pulleys
Once a month remove the belt covers to
remove any accumulation of grass clippings
from around the spindle pulleys and V-belt.
Clean more often when mowing tall, dry grass.
2. Locate the oil drain hose on the engine.
See Figure 4-1.
Figure 4-1
3. Remove the hose from the clip securing
it to the frame.
4. Route the free end of the oil drain hose
toward an appropriate oil collection
container with at least a 2.5 quart
capacity, to collect the used oil.
NOTE: Avoid getting oil on the muffler
when draining.
5. While holding the free end of the
oil drain hose over the oil collection
container, unscrew the square-head
hose plug from the end of the hose. See
Figure 4-1. Drain the engine oil into the
collection container.
6. After draining the oil, wipe any residual
oil from the oil drain hose. Thread the
square head plug into the drain hose
fitting and fully tighten the plug.
7. Refill the engine with new oil. Refer to the
Engine Operator’s Manual for information
regarding the volume and weight of
engine oil.
8. Place the hose back into the clip securing it
to the frame.
NOTE: This Operator’s Manual covers several
models. Tractor features may vary by model.
Not all features in this manual are applicable to
all tractor models and the tractor depicted may
differ from yours.
Maintenance
WARNING! Before performing
any maintenance or repairs,
disengage the PTO, move the
drive control levers fully outward
in the neutral position engaging
the parking brake, stop the
engine and remove the key to
prevent unintended starting.
Lubrication
• Using a pressure lubricating gun,
lubricate the front castor wheel axles
with Cub Cadet 251H EP grease after
every 10 hours of service.
• Periodically lubricate all other pivot
points with a quality lubricating oil.
Engine
Refer to the Engine Operator’s Manual for all
engine maintenance intervals, procedures,
specifications and instructions.
Changing the Engine Oil
WARNING
! If the engine has
been recently run, the engine,
muffler and surrounding metal
surfaces will be hot and can
cause burns to the skin. Exercise
caution to avoid burns.
Maintain oil level as instructed in Engine
Operator’s Manual. Be careful not to spill oil on
any of the belts.
To complete an oil change, proceed as follows:
1.
Run the engine for a short time to warm
the engine oil. The oil will flow more
freely and carry away more impurities.
Use care to avoid burns from hot oil.
Maintenance Schedule
Before
Each use
Every
10 Hours
Every
25 Hours
Prior
to Storing
Check Engine Intake Screen/Cover
P
Clean Transmission Cooling Slots
P
Clean Battery Terminals
P P
Lube Front Wheels
P P
Clean Engine Cooling Fins
P P
Lube Deck Spindles
P
Lube Front Deck Wheels
P P