Cub Cadet Z-Force Pro, Руководство оператора

Страница: 10 / 28

10 S
ection
2 — A
SSembly
& S
et
-U
p
4. Remove the plastic cover, if present, from
the negative battery terminal and attach
the black cable to the negative battery
terminal (–) with the bolt (a) and hex nut (b).
See Figure 2-9.
5. Position the red rubber boot (c) over the
positive battery terminal to help protect
it from corrosion.
NOTE:
If the battery is put into service
after the date shown on top/side of
battery, charge the battery as instructed in
“Charging the Battery” on page 21 prior
to operating the tractor.
Transmission Oil Expansion Reservoir
The transmission oil expansion reservoir
is connected by hoses to the RH and LH
transmission assemblies, and is located behind
the seat box. The function of the reservoir is
to hold the natural expansion of transmission
oil that occurs as the transmission warms up
during operation. DO NOT FILL THE RESERVOIR.
Under normal operating conditions, no oil
should be added to the reservoir. The COLD oil
level should be no higher than approximately
1⁄4” (the “Full Cold” mark) above the bottom of
the reservoir. See Figure 2-10.
Figure 2-10
NOTE:
Prior to the initial operation of the
tractor, the oil level in the reservoir may be
slightly higher than the maximum due to air
in the oil lines. Operation of the tractor will
eventually purge the air from the lines and the
oil level will settle to the maximum.
Install the Rear Hitch Bracket
1. Remove the hex flange screws (a) and
flange lock nuts (b) that secure the
hitch bracket (c) to the bumper bracket.
See Figure 2-11.
a
b
a
b
a
b
c
Figure 2-11
2. Install the hitch bracket (c) as shown
in Figure 2-12 and secure with the hex
flange screws (a) and flange lock nuts (b)
removed in step 1.
a
b
a
b
a
b
c
Figure 2-12