Cub Cadet GT 2544, Руководство оператора

Страница: 25 / 48

25
e. Note the index hole position used for the rear
gauge wheels. Insert a shoulder screw into a
front ball wheel and slide a bell washer onto
the threads of the shoulder bolt.
Note : The
crown (rounded side) of the bell washer should
be against the shoulder of the bolt
. Install the
shoulder bolt and wheel in the corresponding
index hole of the front gauge wheel bracket.
Repeat to install the other front ball wheel.
3. If the gauge wheels have excessive clearance with
the surface below, lower the wheels to the index
hole that provides the approximate 1/2" clearance
as described above.
IMPORTANT: All gauge wheels shoud be installed in
the same relative adjustment index hole location in
each of the gauge wheel brackets.
CUTTING HEIGHT ADJUSTMENT
The mower can be set in multiple positions. Proceed
as follows:
NOTE: If multiple positions are used while mowing, it
may be necessary to adjust the gauge wheels for each
setting to prevent scalping.
1. Push the tractor implement lift handle down slightly
and depress the button on the top of the lift handle.
2. Raise or lower the lift handle to obtain the desired
mower deck cutting height.
3. Release the button when the desired mower
position is obtained.
NOTE: To return the mower deck to a specific position,
note the position of the lift lever before raising or
lowering the mower deck.
LUBRICATION GUIDE
WARNING: The service life and reliability of any machine depends upon the care it is given.
Proper lubrication is a very important part of that care. This lubrication schedule reflects the
minimal requirements to maintain the equipment. More frequent inspections and maintenance is
preferable.
NOTE : We do not recommend the use of a pressure
washer or garden hose to clean your unit. They may
cause damage to electrical components; spindles;
pulleys; bearings; or the engine. The use of water will
result in shortened life and reduce serviceability.
Using the lubrication illustration as a guide, make
certain that all lubrication fittings are installed and
functioning.
Be sure all fittings are free from dirt and paint so the
lubricant is certain to enter the bearing.
Using a pressure lubricating gun, always force the
lubricant through the full length of each bearing until it
emerges at the end, carrying with it the worn lubricant
and any dirt that may have entered the bearing.
Miscellaneous working parts not provided with
lubrication fittings should be oiled regularly with a good
grade of lubricating oil.
Always lubricate the tractor thoroughly before taking it
to a remote location for a prolonged period of time.
Lubricant is cheap. Use plenty of it. Worn parts can be
expensive to replace.
Keep your supply of lubricating oil and grease stored in
clean containers, and covered to protect from dust and
dirt.
Keep the lubricating gun nozzle clean and wipe dirt
from the grease fittings before lubricating.
The symbols in the illustrations indicate the method of
application and the hourly intervals to apply the
lubricant.
Use a pressure lubricating gun
and apply 251H EP grease (or
equivalent No. 2 multi-purpose
lithium grease) sufficient to flush
out the old grease and dirt.
Lubricate at the hourly intervals
indicated on the symbols.
Dipstick, use to check engine and
transmission oil before each use.