Cub Cadet FM48, Руководство оператора

Страница: 21 / 52

same amount to the wheel arm grease fittings (see fig. 9) . See the driveline
manufacturer operator's manual for further information on the driveline.
2. Gearbox oil level: check gearbox oil level, it should be between 1 /
2
and 2 /
3
full. If
needed add either SAE 90 wt. or SAE 140 wt. gear oil.
Every 25 hours: check hardware tightness; mower vibrations can loosen bolts 10 .
Check tightness of the hardware periodically, using this table as a guide.
Every 50 hours:
1. Lubricate the three spindles with two or three shots of multipurpose grease (see
fig. 10) . The top grease fittings are easily accessible from the top of the deck by
simply removing the plastic dust guards.
2. Check belt tension 11 .
4.03 - Blade Maintenance
WARNING: To avoid possible injury always wear proper eye and hand protection
when servicing mower blade.
In order for the mower to work properly and to always obtain a precision cut with lower
HP requirements thus keeping cost down, proper blade maintenance is important.
Blades must be kept sharp, at their original length and corners maintained. A blade
must be replaced if, due to wear or damage, its original shape has been distorted.
FM48/FM60/FM72 O
PERATOR
’
S
M
ANUAL
M
AINTENANCE
21 C
UB
C
ADET
Y
ANMAR
11 See section 4.04 - Belt Tension.
10 See table 1, page 28.
Fig. 10
Lubrication of the spindle
shafts easily accessible from
the top of the deck.