Rev. -, p. 9 of 15
9. SOFT REAR CURTAIN
9.1 If not installing a soft rear curtain, skip to step 10
below.
9.2 Snap the rear curtain (see fig. 9.2) to the factory
installed snaps on the inside surface of the back of the
roof (6 snaps). Note: the pocket pleat should be outboard
towards the rear of the tractor.
9.3 Per fig. 9.3, apply PSA (pressure sensitive adhe-
sive) hook velcro to the back inside surface of the verti-
cal rear tube of the side frames. Continue the hook velcro
90 degrees on to the top of the lower side frame tube then
down 90 degrees and on to the yellow fender of the trac-
tor. Note: surfaces must be clean, dry, and at room tem-
perature for best adhesion.
10. UNDERSEAT FILLER
10.1 Tilt the seat forward. Fig. 10.1 shows the underseat
filler. Attach the top straight edge of the underseat filler
(which has velcro sewn on) to the bottom of the previ-
ously installed rear curtain which has the mating velcro
sewn on or to the bottom of the hard rear panel which
will need to have the supplied PSA hook velcro installed
on the bottom inside surface. Note: orient the underseat
filler so that the right side has the four-way slit that goes
over and around the seat belt receiver (see fig. 10.1). In-
stall more of the supplied PSA hook velcro to suit (at the
installer’s discretion). See fig. 10.1.1. Reminder: make
sure the surfaces are clean, dry, and at room temperature
for best adhesion.
Fig. 9.3 (view from right front side of tractor)
vel
velcro here
vel-
4-way slit on right
side to go around
seat belt receiver
Fig. 10.1 (view from left side of tractor)
Fig. 10.1.1 (view from right side of tractor)
velcro here
Fig. 9.2
Fig. 10.1
