Fig. 4.2 (view of right rear leg)
Rev. -, p. 5 of 15
3. SIDE FRAMES (cont’d.)
3.3 Place the side frame onto the tractor making sure
that the contour bulb rubber that sits on the fender is all
pointing outboard. Per fig. 3.3, install the M8 bolt and
washer through the rear inboard mounting tab then
through the 1/4” thick rubber washer and into the factory
installed weldnut on the tractor.
Caution
: use extreme
care when starting to engage these threads to avoid cross
threading and damaging these permanent weldnuts. Per
fig. 3.3.1, install the front floorboard bolt so the rounded
bolt head is up top and the locknut is underneath the trac-
tor floorboard. Use the following hardware: 5/16-18 x 1”
long button head bolt, one standard steel washer, one
fender washer (under tractor floorboard) and one locknut.
Leave bolt loose. Repeat for opposite side of tractor.
3.4 If installing an optional hard rear panel at this
time, skip to step 4 below. If installing the standard soft
rear curtain, proceed with step 3.5 below.
3.5 Attach the roll bar mount to the back side of the
side frame using the following hardware per side: two
5/16-18 x 3/4” long button head bolts, two plastic wash-
ers, and two steel washers into the factory installed
threaded inserts. See fig. 3.5. Leave loose. Repeat for
opposite side.
4. OPTIONAL HARD REAR PANEL
4.1 If not installing an optional hard rear panel at this
time, skip to step 5 on the next page.
4.2 Per fig. 4.2, assemble the supplied vibration
mount to the right rear leg using one 1/4-20 x 3/4” long
button head bolt, two steel washers, and one locknut. The
vibration mount as well as the head of the bolt are to be
on the same side of the leg as the long bent up flange.
Install in the middle hole as shown. Repeat for the left
rear leg.
Fig. 3.3 (view from right front side of tractor)
metric hex bolt and
5/16” steel washer here
Fig. 3.5 (view from right rear side of tractor)
install these
two bolts
floorboard
bolt here
(5/16” x 1” long)
Fig. 3.3.1 (view from right side of tractor)
long flange
is shown
bent up in
the photo
vibration
mount and
head of bolt
on this side
1/4” thick rubber
washer under here
