Cub Cadet 769-12285, Оригинальная инструкция по эксплуатации

Страница: 24 / 126

Transport and storage
24
769-12285
EN
replacing the line spool (Fig .
O
)
WArNING!
Risk of injuries due to the cutting tool.
¾
Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾
Do not reach into the area of the rotating
line.
¾
Always remove the power pack prior to
working on the device.
Î
Simultaneously strongly press both of the en-
gaging lugs of the spool cap together
O 1
and
pull it off
O 2
.
Î
Remove the line spool
O 3
.
Î
If necessary, remove any dirt.
Î
Thread the line ends of the new spool through the
eyes of the line box
O 4
and insert the new line
spool in the line box
O 5
.
Î
Extend the line ends out of the spool fas-
tening
O 6
.
Î
Simultaneously strongly press both of the en-
gaging lugs of the spool cap together and push it
on to the line spool until it engages
O 7
.
transport and storage
WArNING!
Risk of injuries due to the cutting tool.
¾
Before transport or storage, switch off
the device and wait until the cutting tool
comes to a standstill.
¾
Remove the power pack before transport
or storage.
Storage
Î
Thoroughly clean your device after every season.
Î
Always store the device in a dry and safe location
that is inaccessible to children.
Î
Store the power pack and trimmer separately.
Î
Store the power pack in a cool and dry location.
Recommended storage temperature approx.
18 °C.
Î
Keep the trimmer and especially its plastic com-
ponents away from brake fluids, petrol, mineral
oil containing products, penetrating oils etc. They
contain chemical substances that can damage,
attack or destroy the plastic components of the
trimmer.
Î
Fertilizers and other garden chemicals contain
substances that may have a highly corrosive
effect on the metal parts of the trimmer. Therefore
do not store your trimmer in the vicinity of these
substances.
troubleshooting
WArNING!
Risk of injuries or material damage
¾
In case of doubt always consult a specialist workshop.
¾
Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause remedy
The device switch-
es off.
The power pack is too hot. Allow the power pack to cool.
The power pack is discharged. Charge the power pack.
The temperature of the device (electronics) is too
high.
Allow the device to cool and if necessary,
clean the ventilation slots
Overcurrent release If this occurs again take your device to a
specialist workshop.