Service
7
18
Belt Replacement
Belt Removal Preparation
1.
Disconnect the chute crank assembly at the discharge
chute end by removing the hairpin clip and the flat washer.
Refer to Figure 7-1.
Figure 7-1
2.
Remove the hex screws and lock nuts securing the forward
end of the support tubes to the back of the auger housing,
and pivot the tubes upward.
3.
Remove the plastic belt cover on the front of the engine by
removing the three self-tapping screws. See Figure 7-2.
Figure 7-2
4.
Loosen the bolt shown in Figure 7-3 securing the belt
keeper bracket and remove the other bolt. Push the belt
keeper bracket up off the engine pulley. Refer to Figure 7-3.
Loosen
Remove
Figure 7-3
Auger Belt Replacement
To remove and replace your snow thrower’s auger belt, proceed
as follows:
1.
Remove the hairpin clip and flat washer from the ferrule
in order to disconnect the auger idler rod from the brake
bracket assembly. See Figure 7-4.
Figure 7-4
NOTE:
Make sure to maintain the location of the ferrule on the idler
rod.
Содержание 2X 945 SWE
Страница 25: ...Notes 25 ...