background image

Step 2

Insert 

detergent suction tube
into 1 gallon of fresh
water. Siphon water at
low pressure for one
minute.

Step 3

Turn

the switch to off (O)
position and unplug
cord from outlet.
Turn off the water
source.

Step 4

Press

trigger to release
water pressure.

SHUTTING DOWN & CLEAN-UP 

7

WINTERIZING AND LONG-TERM STORAGE    

1. Disconnect all water connections.

2. Turn on the machine for a few

seconds, until the water which 
had remained in the pump exits. 
Turn off immediately.

3. Do not allow high pressure hose 

to become kinked.

4. Store the machine and accessories in 

a room which does not reach freezing
temperatures.

Caution: Failure to follow the above 
directions will result in damage to the 
pump assembly and accessories.

TAKING A BREAK... five minutes or more

Step 5

Disconnect

the garden hose from the
water inlet on the unit.

Step 2

Turn pressure
washer to off 
(O) position.

Step 6

Disconnect the high pressure hose from the

high pressure outlet and engage the gun safety lock.

Step 1

Engage gun
safety lock.

Step 1

Remove 

detergent suction
tube from detergent
reservoir.

8

CLEANING TIPS                       

Deck Cleaning

(with or without detergent)

Pre-rinse deck and surrounding area with
fresh water. If using Cub Cadet Deck Wash,
place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure. For best results, limit your
work area to smaller sections of
approximately 25 square feet. Allow Cub
Cadet Deck Wash to remain on surface 1-3
minutes. Do not allow detergent to dry on
surface. Rinse at high pressure in a long
sweeping motion keeping the spray nozzle
approximately 3-6 inches from the cleaning
surface. Always clean from top to bottom
and from left to right. When moving on to 
a new section of the cleaning surface, be
sure to overlap the previous section to
eliminate stop marks and ensure a more
even cleaning result. 

Caution: Do not use Rotating spray wand
on wood surface as it may cause damage.

House Siding

(with or without detergent)

Pre-rinse cleaning surface with fresh water.
If using Cub Cadet All Purpose Cleaner,
place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure (for best results, limit your
work area to sections of approximately 6
feet and always apply detergent from
bottom to top). Allow Cub Cadet All Purpose
Cleaner to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface, if
surface appears to be drying, simply wet
down surface with fresh water. If needed,
use special Wash Brush Attachment to
remove stubborn dirt. Rinse at high
pressure from top to bottom in an even
sweeping motion keeping the spray nozzle
approximately 6 inches from the cleaning
surface. 

Caution: Do not use Rotating spray wand
on siding as it may cause damage.

Cement Patios, 
Brick and Stone 

(with or without detergent)

Pre-rinse cleaning surface with fresh water.
If using Cub Cadet All Purpose Cleaner,
place detergent suction tube directly into
cleaning solution and apply to surface at
low pressure. For best results, limit your
work area to smaller sections of
approximately 25 square feet. Allow Cub
Cadet All Purpose Cleaner to remain on
surface 1-3 minutes. Do not allow detergent
to dry on surface. Rinse at high pressure in
a sweeping motion keeping the spray
nozzle approximately 3-6 inches from the
cleaning surface. Always clean from top to
bottom and from left to right. For removing
extremely stubborn stains, use Cub Cadet
Rotating spray Wand.

Cars, Boats & Motorcycles

(with or without detergent)

Pre-rinse vehicle with fresh water. If using
Cub Cadet Vehicle Wash, place detergent
suction tube directly into cleaning solution
and apply to surface at low pressure. 
For best results, clean one side of vehicle
at a time and always apply detergent from
bottom to top, do not allow detergent to
dry on surface. If needed, use special Wash
Brush Attachment to remove stubborn dirt.
Rinse at high pressure in a sweeping
motion keeping the spray nozzle approx-
imately 6-8 inches from the cleaning
surface (distance should increase when
rinsing pin-striping or other sensitive
surfaces). Always clean from top to bottom
and from left to right. For best results, 
wipe surface dry with a chamois or 
soft dry cloth. 

Caution: Do not use Rotating spray wand
on vehicles as it may cause damage.

Содержание 1400E









Отзывы: