CTI 062-00108, Инструкция по установке и эксплуатации

Страница: 21 / 37

C T I 2552 Installation and O peration G uide
11
Figure 8 Configuration Jumper Locations
WARNING:
Remove power from the I/O base before inserting or removing a module.
2.5 Inserting the Module Into the I/O Base
Insert the module into the I/O base by carefully pushing the module into the slot. When the module is
fully seated in the slot, tighten the captive screws at the top and bottom to hold the module in place. To
remove the module from the I/O base, loosen the captive screws, then remove the module from the I/O
base. Be careful not to damage the connector card at the back of the module when inserting or
removing the module.