RadioPro IP Gateway
Installation and Configuration Guide NEXEDGE NX-57xx/58xx
12
Step 1a. for
NEXEDGE NX-57xx/58xx
:
Configure Voice Control Station Radio(s) using Kenwood FPU
(For NX-700/800 radios see document # S2-61904.)
Radio models NX-5700/5800 can be used as a control station radio.
Use the KPG-D1N
FPU
(Kenwood’s NEXEDGE ‘Field Programming Utility’ configuration software for NX-7x0/8x0
radios) to configure NEXEDGE radio parameters using the following steps.
1.
Connect and read the control station as any other radio
Using a Kenwood programming cable, connect the NX-5700/5800 Control Station radio to a PC or
Notebook that has the correct Kenwood FPU version (KPG-D1N in this case).
Open the
KPG-D1N
FPU.
Ensure that the correct COM port is selected.
From the
Model
tab, choose the
Product Information
page, and then click the
Read Configuration
button as shown below.
Enable
Feature Selections
that this radio is licensed for with a check mark in the appropriate boxes,
and then click the
OK
button.
Kenwood FPU