CTD DMC70A, Инструкция по эксплуатации и руководство по техническому обслуживанию

Страница: 13 / 24

Cutting Cutting
Cutting Cutting Cutting Aluminum:
Aluminum:
Aluminum: Aluminum: Aluminum:
As with cutting any material, it is important that aluminum be clamped properly. Precision blades are required
for accurate cutting. CTD suggests and uses a Triple Chip Grind on all its nonferrous Carbide Blades. When
cutting aluminum, or other nonferrous materials, it is essential that the blades be lubricated with a Saw Blade Lubrication
System or other blade lubricating system for the finest finish. See SAWBLADE LUBRICATION SYSTEM
below for more details.
Combination Blades: Combination Blades:
Combination Blades: Combination Blades:
Combination Blades:
Any combination blade is basically an aluminum cutting blade. Significant blade life in between sharpenings
will be lost if a blade is used for cutting both aluminum and wood. The amount of production for either wood
or aluminum should be the determining factor in the assessment of the particular blade type to be used. Please
consult factory.
Sawblade Lubrication System: Sawblade Lubrication System: Sawblade Lubrication System: Sawblade Lubrication System: Sawblade Lubrication System:
The Sawblade Lubrication System is used when cutting aluminum or other nonferrous material . This system normally
uses a Water Soluble Oil mixture of
10 parts water to one part oil. The system operates by siphoning the lubrication up
the line to the spray nozzle. Any air leak will cause inconsistent fluid flow to the spray nozzle. BE BE
BE BE BE SURE your fluid is free
from chips and other debris. A fluid container supplied with the machine contains a One-Way Check Valve, Part No.
B3P96 at the end of the clear fluid line. This check valve helps to hold the lubrication in the line. However, after a couple
of minutes the lubrication or oil will back-flow into the container. Priming of the system may be necessary if the machine has
been standing without use. The system may be shut off by closing the toggle valve next to the vacuum pump. The fluid
must be clean or the vacuum pump will clog.
CTD Bio Lubrication System: CTD Bio Lubrication System:
CTD Bio Lubrication System: CTD Bio Lubrication System:
CTD Bio Lubrication System:
The CTD biodegradable lubrication system operates by pulse spraying a minute amount of biodegradable lubri-
cant directly on to the saw tooth of the blade in time-measured increments. The majority of the lubricant then
dissipates with the heat of the cutting action. Chips coming off the blade are hot and dry, and are more easily collected
(see specific instructions included with system).
-13-