CTD DM200R, Инструкция по эксплуатации и руководство по техническому обслуживанию

Страница: 10 / 35

1/4” elbow
B3P61
shut off
valve
200M22
vert. cyl.
brkt.
2B3P20
3” stroke
air cyl.
2B3P20C
vert. clamp
pad
200BIP22
wing nut
VC
1/4” red polyflo
200B7P19
adjustable
lock
200M21
vert. clamp
adjustment
brkt.
200M20B
horiz. bar adj.
for vert.
200M20
vert. clamp
support bar
Diagram “E”
Vertical Clamp Assy.
material must lay
flat on base and
work supports
never allow material to rest uneven
on base or work supports
-10-
Cutting Speed:
The blade is rotating at approximately 3700 RPM for Model DM200R. For Model DM400, the 16” machine’s blade rotates
at 2900 RPM and the 20” machine’s blade rotates at 2700 RPM. When moving the blade through the material, the blade
must NEVER be allowed to dwell in the work. If fine finishes are required;
1. Use a sharp blade.
2. Use a CONSTANT , EVEN PRESSURE when cutting through the material.
Clamping and Work Slippage:
The work must NEVER be allowed to move or vibrate as it is being cut, or inconsistent cuts will result. Two inside
Vertical Clamps, which hold material down against the table base are provided as a standard feature on all double end
trim saws. For odd shapes and profiles, additional clamping or fixturing may be necessary. Horizontal Clamps that
push the material back against fence, can be provided as an optional accessory. The Horizontal Clamps mount to the
Center Supports that hold the Vertical Clamps for the DM400. They mount to special inside supports for the DM200R. The
Horizontal Clamps are adjustable front to back on the Center Supports for different widths of material. The clamps are
actuated prior to the saw head by depressing the Foot Valve. An Anti-Tie Down, Two-Hand Control drives down the saw
heads. Check your material for squareness using a 90  square. Material that is out of square will move when it is cut, causing
irregular mitres. (See “IRREGULAR MITRES” on Page No. 17.) Additional tooling may be neeeded. Consult factory for
more information.
Cutting the Material:
The material to be cut (both the incoming pieces and the cut pieces) must lay flat on the table base, or the blade
may bind the material. THIS CAN DAMAGE THE BLADE OR THROW THE CUT PIECE OUT OF THE
SAW, POSSIBLY HARMING THE OPERATOR (see Diagram “C“ below).