background image

Computer Technology Corporation

5

PowerStation Flash Memory Replacement

flash setup disk. This format procedure will erase all data on the module.

Important

DO NOT use the PowerStation's DOS Format command to format 
the flash memory.

1.

Insert the flash setup disk into the PowerStation’s floppy drive.

2.

Power up the PowerStation.

3.

Select option 2 from the Startup Menu, and press Enter to begin the 
flash memory test.

Warning

The flash memory test erases the flash memory prior to testing the 
capabilities of the flash memory. Be sure to back up any important 
data stored on the module before you begin the flash memory test.

4.

Press <Y> to continue with the flash memory test when the warning 
message appears.

5.

Press any key to reboot the PowerStation when the test is complete.

6.

Select option 1 from the Startup Menu, and press Enter to format the 
flash memory and make it bootable. The setup utility copies the most 
common DOS commands onto the flash memory.

7.

When the flash memory preparation is complete, remove the flash set-
up disk. Failure to remove the disk will restart the cycle when you re-
boot the PowerStation.

8.

Press any key to reboot the PowerStation. The flash memory becomes 
drive C.

Note

The above procedure does not install the shell. The shell must be 
installed using the shell installation disk.

Отзывы: