Computer Technology Corporation
3
PowerStation Flash Memory Replacement
System Support Card.
2.
Push outward on the socket ejectors. It might be necessary to use a
small screwdriver or the tip of a pen to push on the ejectors.
3.
Gently flip the flash memory module upright from the 45-degree an-
gle.
4.
Pull the flash memory module outward to remove. Place the flash
memory module on an anti-static surface.
Installing a Flash Memory Module
The steps to installing a flash memory module are the reverse of removing
a module. Follow these steps to install a flash memory module:
1.
Insert the flash memory module into the socket with the notch on the
memory module to the left. The notch on the memory module aligns
with the ridge on the socket. Refer to the picture below:
2.
Gently push the module down to a 45 degree angle until the tabs on the
socket snap onto the flash memory module. Make sure the socket ejec-
tors are holding the flash memory module in place.
System Support
card
flash memory
module
tabs of SIMM socket
fit these holes
ridges of SIMM
socket fits these
notches
