CSI LV-019, Руководство по обслуживанию, Страница: 25 / 25

Signature 2 Series
pg. 25
SYMPTOMS PROBABLE CAUSE CORRECTION
5. High salt usage High salt setting Adjust brine tank refill time
Excessive water in brine tank See symptom # 7.
Constant flow through the unit Indicates plumbing leak (i.e. toilet
tank)
Improperly set hardness Reset programming
6. Loss of water
pressure
Scaling / fouling of inlet pipe Clean or replace pipeline.
Pretreat to prevent.
Fouled resin Clean resin. Pretreat to prevent.
Improper backwash Too many resin fines and/or sediment.
Call dealer. Reset backwash flow rate,
and/or adjust.
7. Excessive water in
brine tank and/or
salty water to
service
Plugged drain line Check flow to drain. Clean flow
control.
Dirty or damaged brine valve Clean or replace brine valve.
Plugged injector Clean injector and replace screen.
Low inlet pressure Increase pressure to allow injector to
perform properly. (20 psig minimum)
Excessive brine refill cycle time Reset brine refill cycle time.
8. Softener fails to
use salt
Check items listed in #1
Improper control valve programming Check and reset programming
Plugged/restricted drain line Clean drain line and/or flow control
Injector is plugged Clean or replace injector and screen
No water in brine tank Check for restriction in BLFC. Ensure
safety float is not stuck. Check brine
tank for leaks.
Water pressure is too low Line pressure must be at least 20 psi.
Brine line injects air during brine draw Check brine line for air leaks
Internal control leak Call dealer. Check piston, seals and
spacers for scratches and dents.
9. Control cycles
continuously
Faulty circuit board Replace circuit board.
10. Continuous flow to
drain
Foreign material in control Call dealer. Clean valve, rebuild unit.
Internal control leak Same as above.
Valve jammed in backwash, brine or rapid
rinse position Same as above.
Motor stopped or jammed. Replace motor.