CSI CARDPIN1, Руководство по установке

Страница: 14 / 60

CSI Key/Card Readers Installation Guide
8 CSI Readers
The key/card reader may also be flush-mounted in a protective enclosure or surface-
mounted in a protective enclosure. The key reader can be flush-mounted in a standard
single gang switch enclosure. The card reader requires a larger flush mount box, which
is available from CSI. Contact CSI with specific questions regarding mounting methods.
Installation Procedure for Key/Card Reader with Pushbutton
If you want to install an entry reader and a pushbutton exit device (pushbutton supplied
by your dealer) at the same door, proceed as follows:
Caution: Before making mounting holes, make sure that wall, door frame, or other applicable area is
clear of obstructions such as conduits, pipes, glass, wiring, etc. A minimum depth of 2
1
⁄
2
"
(6.35 cm) is required between surfaces for clearance of the key/card reader and connector.
1. Install the key/card reader using a U-bracket. Refer to “Installation Procedure for
Single Key/Card Reader” on page 5 for instructions.
2. Install the pushbutton and cover plate as shown in Figure 7 . Using 18 AWG
(0.897 mm
2
) twisted-pair, shielded cable, attach the pushbutton to the release
terminals, GND and D REL, on the CSI Door Processor Unit.
Note: For a U.L. configured system, the exit pushbutton must be a U.L. listed connector and
switch of compatible rating for the DPU’s release input. Refer to the appropriate DPU
Installation Guide for more information.
Figure 7. Key/Card Reader/Pushbutton Installation
Door Jamb or Mullion
U-Bracket
INSIDE
(Exit)
OUTSIDE
(Entry)
Card Reader
requires two
screws
Cover
Plate
Pushbutton
6
/
32
" (4.8 mm)
Screw
6
/
32
" (4.8 mm)
Screw
Key/Card
Reader