CSI CARDPIN1, Руководство по установке

Страница: 11 / 60

Installation Guide CSI Key/Card Readers
CSI Readers 5
will also need to install a key/card reader low temperature package for proper operation
below 30˚F (–1˚C).
Note: U.L. listed versions of key/card readers are provided with an enclosure and the low temper-
ature package.
In all applications, an average height for installing the key/card reader for ease of use is
approximately 48 inches (122 cm) from the floor or ground level as applicable.
Required Tools
✦
Marking scribe or pencil
✦
6" Ruler (15.24 cm)
✦
1" (2.54 cm) Hole saw or 1" (2.54 cm) square knockout punch
✦
Drill and
9
⁄
64
" (3.6 mm) drill bit,
3
⁄
8
" (9.5 mm) if knockout punch is used
✦
No. 2 Phillips screwdriver
✦
File
Installation Procedure for Single Key/Card Reader
Before installing the key/card reader as shown in the following procedure, insert the RJ45
reader cable plug into the jack provided on the reader.
Caution: Before making mounting holes, make sure that wall, door frame, or other applicable area is
clear of obstructions such as conduits, pipes, glass, wiring, etc. A minimum depth of 2
1
⁄
2
inches (6.35 cm) is required between surfaces for clearance of the key/card reader and
connector.
1. Locate and make a cutout for mounting the key/card reader as shown in Figure 3 .
2. Secure the key/card reader in place by following the directions in A or B below.
a. Locate and drill a
9
⁄
64
" (3.6 mm) diameter hole in the door jamb or mullion
opposite the key/card reader mountiBng hole (single hole for key readers, two
holes for card readers. Make required electrical connections, then position
Figure 2. Model CRDRDR Card Reader and Model KEYRDR Key Reader