32", 42", and 50"
Installation Instructions
6
7.
Tighten three wing nuts on spacer assembly.
8.
Slide top of
LOWER
spacer mounting bracket into
UPPER
spacer mounting bracket until it stops.
(See Figure 4)
NOTE:
Wing nuts should be facing towards rear of frame
when spacer assembly is properly installed.
9.
Slide spacer locking tab towards front of frame.
(See Figure 4)
Figure 4
10. Locate IR receiver on display. (See Figure 5)
11. Remove protective cover from back of IR Replicator.
(See Figure 5)
12. Position IR Replicator inside frame so that when
frame is mounted on display the IR Replicator is
positioned directly in front of IR Receiver on display.
(See Figure 5)
13. Secure IR Replicator to inside of frame by pressing
adhesive back on IR Replicator against frame.
14. Pull straps on frame back over top of frame.
(See Figure 6)
15. Align back side of frame with front of display.
(See Figure 6)
16. Route wire from IR Replicator with plug out of frame
at lower corner. (See Figure 6)
Figure 5
17. Slide frame onto display until display front presses
against inside of frame.
IMPORTANT ! :
Make sure spacer alignment bar is
resting on top of display.
Figure 6
Spacer Locking Tab
Upper Spacer
Mounting Bracket
IR Receiver
(example Location)
IR Replicator
Adhesive back
Straps
Wire with Plug
From IR Replicator
Spacer Alignment
Bar
