32" O.C. MAX.
[812.8mm]
P-OMAN HANDRAIL
TYPICAL HANDRAIL ASSEMBLY
24POMAN
1.
USING "LOCAL CODE" REQUIREMENTS, ESTABLISH HANDRAIL HEIGHT ABOVE FINISH FLOOR. DEDUCT 3 3/8" [85.7mm] AND SNAP A CHALK
LINE AT THAT HEIGHT. THIS MARKS THE LOCATION OF THE HOLE FOR THE MOUNTING BRACKET FASTENERS.
2.
DRILL CLEARANCE HOLES IN WALL SURFACE FOR MOUNTING HARDWARE. REFERENCE CHART ON PAGE 2 FOR CORRECT DRILL
DIAMETERS.
3.
INSTALL MOUNTING BRACKETS USING APPROPRIATE FASTENERS. DO NOT OVER TORQUE FASTENERS. USE A LEVEL TO ENSURE THAT
THE BRACKETS ARE LEVEL.
NOTE: SEE LAYOUT VIEW TO AID IN MOUNTING BRACKET LOCATION.
4.
CUT THE CONTINUOUS POWDER COATED HANDRAIL TO LENGTH USING THE REQUIRED DEDUCTIONS (REFERENCE LAYOUT VIEW).
NOTE: IT IS RECOMMENDED THAT CONTINUOUS POWDER COATED HANDRAIL BE CUT WITH AN 80-100 TOOTH CARBIDE TIPPED SAW BLADE OR
EQUIVALENT.
5.
ATTACH END CAPS AND OUTSIDE CORNERS:
·
ALIGN HANDRAIL WITH END CAP SO THEY ARE FLUSH TOGETHER.
·
USING OUTSIDE MOUNTING PLATE AS A TEMPLATE, PLACE INTO GROOVE AND MARK THE HOLE LOCATIONS.
·
REMOVE OUTSIDE MOUNTING PLATE AND DRILL HOLES (
∅
1/8" DRILL).
·
ALIGN HOLES OF INSIDE MOUNTING PLATE, HANDRAIL AND OUTSIDE MOUNTING PLATE.
·
ATTACH USING #6-32 x 3/4" FH MACHINE SCREWS. DO NOT FULLY SECURE.
·
REPOSITION END CAP AND ATTACH USING #6-32 x 3/4" FH MACHINE SCREWS.
·
SECURELY TIGHTEN ALL FASTENERS.
6.
DRILL 1/16" PILOT HOLES INTO THE POWDER COATED HANDRAIL FOR MOUNTING BRACKET ATTACHMENT. MOUNTING BRACKETS ARE TO
BE LOCATED 3" [76.2mm] FROM EACH END OF THE POWDER COATED HANDRAIL AND 32" [612.6mm] ON CENTER ALONG LENGTH, AS
REQUIRED.
7.
FASTEN THE POWDER COATED HANDRAIL TO THE WALL BRACKETS IN SUCCESSION BY INSERTING TWO #6 x 5/8" PHILLIPS FLAT HEAD
SHEET METAL SCREWS THROUGH THE UNDERSIDE OF BRACKET INTO THE POWDER COATED HANDRAIL. CAUTION: OVER-TORQUEING
MAY CAUSE THE FASTENERS TO STRIP.
POWDER COATED
HANDRAIL END CAP
POWDER COATED HANDRAIL
POWDER COATED
HANDRAIL OUTSIDE
CORNER
FASTENER #5
HANDRAIL END CAP
OUTSIDE MOUNTING PLATE
FASTENER #3
HANDRAIL SPLICE
PLATE WITH
FASTENER #3
HANDRAIL END CAP
INSIDE MOUNTING PLATE
POWDER COATED
HANDRAIL END CAP
SPECIFIED FASTENER
PLATFORM MOUNTING BRACKET
Doc#: II-24POMAN
Issue Date: 03/23/10
Rev Date: 11/09/18
