Crystal SJ-3560, Руководство пользователя

Страница: 7 / 19

A s s e m b l y S t e p 2
Page 6
Insert the tip of the Tension
controller (#16) wire into the
Tension Controller Cable (#17)
head at an angle. Tilt the Tension
Controller (#16) wire into the
crevice and then pull upward.
TENSION WIRE ASSEMBLY
H a r d w a r e R e q u i r e d
Washer
Bolt
#43. Arc Washer (M8)
[4 pieces]
#47. Spring Washer (M8)
[4 pieces]
#34. Bolt (M8x15 mm)
[4 pieces]
Cable & Front Post Assembly
Remove the pre-assembled parts from Main Frame
(#01)
and set them aside nearby: Four
Bolts (#34),
four Spring Washers (#47) , and four Arc Washers
(#43) .
With the help of an assistant, connect
Monitor Wire
(Middle) (#19) to Monitor Wire (Lower) (#18) as
show in exploded diagram A, and Tension Controller
(#16)
to
Tension Controller Cable (#17)
as shown in
exploded diagram B.
Then, being careful to tuck the connected wires into
the hollow tubing to avoid pinching/damaging the wires,
slide
Front Post (#05) onto the protruding tube of
Main Frame (#01) . Secure using a total of four Bolts
(#34) , four Spring Washers (#47) , and four Arc
Washers (#43)
that were set side nearby.
A
B
Assembly Instructions
SJ-3560