Crystal RS363SF X9, Руководство пользователя, Страница: 14 / 30

RS363SF X9 User Guide
Using Jonathan Rails
To install the product with Jonathan Rails in an equipment rack, complete the following
steps below and see
Figure 3 on the following page.
1. Attach a bracket (see #6 in Figure 3) to the smooth side of the Jonathan rail that has four
or more holes in a row (see #9 in Figure 3). There are five slots on each bracket; when
attaching to the rail side with the row of holes, place the first screw in the second slit back
from the ear. Make sure the arrow marking is pointing downward.
2. Slowly extend the rail to view the screw access hole that will allow attachment of the four
8-32 x 0.313” screws with four 8-32 X 0.344” keps nuts (see #10 in Figure 3). Place a screw
in the first hole and slide the rail to the second hole to insert a screw. Continue until all
four screws have been inserted. If the rail slides too far before placing a screw in one of
the holes, it may lock into position. Unlock rail by pressing down on the lock mechanism
(see # 11 in Figure 3).
3. Rail should be fully extended after placing the four screws in the holes and securing to
the bracket.
4. Set the appropriate length and attach two 8-32 x 0.313” screws with two kep nuts in the
two longer slits provided. Make sure the arrow marking is pointed downward. Keep rail
fully extended (see #’s 1 and 2 in Figure 3).
5. Repeat steps 1-4 for the second rail.
6. With rails fully extended, locate the four holes used to attach the rails to each side of the
server. Make sure the rails are positioned with the arrow markings pointed downward.
7. Secure to the server using four 8-32 x 0.313” screws for each side.
8. An assistant may be needed: Attach the chassis into the rack mount by installing eight
10-32 x 0.50” screws into the top and bottom holes of the bracket ears (two for front
right; two for front left; two for back right and two for back left bracket holes) (see #’s 3,
6, and 7 in Figure 3).
9. To secure the server when transporting or when extension of the chassis from the rack is
not necessary, screw two 10-32 x 1” screws in the middle hole on the front bracket ears
(see #4 in Figure 3).
RS363SF X9 User Guide Page 12 of 26