Crystal Vision
Card edge operation
SW221 3G User Manual R1.4
10
01/09/2016
3.4 Reading card edge LEDs
Card edge LEDs may be used in conjunction with status information from any connected
remote status panel display or from Statesman if available.
Refer also to the trouble-shooting chapter for more help with solving problems and monitoring
status information.
The following table summarises the card edge LED functions and colours:
Name
LED
Colour
Function when ON
Function when Off
IP 1
Yellow
Input 1 present
Input not present
IP 2
Yellow
Input 2 present
Input not present
PSU
Green
Good power supply (PSU) rails
One or more of the monitor
supplies is out of specification
Yellow
Not currently supported
IN1 OP1
Yellow
Output 1 showing input 1
IN2 OP1
Yellow
Output 1 showing input 2
IN1 OP2
Yellow
Output 2 showing input 1
IN2 OP2
Yellow
Output 2 showing input 2
3.5 Navigating card edge menus
To access the card edge menu system proceed as follows:
•
Press the up-arrow [
] until a top menu category is reached
•
Rotate the SCROLL control until the desired menu category is found
•
Push ENTER to enter the sub menus of that category
•
Rotate SCROLL to select a sub menu
•
Push ENTER to select the desired function. Selection will be indicated by the text
being displayed in
italic
text
•
Rotate ADJUST to make the desired change to the selected parameter. The display
brightness will flash slowly to indicate that a change has been made and requires
confirmation
•
Push ENTER to action the change. The display will cease flashing
•
Use the up-arrow [
] and SCROLL control to navigate to further menus
Notes:
The displayed menu brightness will flash slowly if confirmation of a change is required.