Crystal Vision
Hardware installation
13/01/05
12
DDAA132 User Manual R7.2
Changing the standard selection mode
With PL8 in the AUTO position the board will automatically adjust to the 525- or 625
line video standard of the incoming serial digital data.
With PL8 in the MANUAL position the video standard used will be set by the front panel
DIL switch or GPI control.
DDAA132 showing configuration jumpers
Note:
The AUTO mode may slightly extend the time required to synchronise a new signal.
Changing output signal formats
The following table shows the link position required to select composite or Y/C video for
the RM01, RM02, RM18 rear connectors and older frames.
DDAA132 showing configuration jumpers
