Crysalli Beverage Systems
a division of WPD
1739 Sabre Street, Hayward, CA 94545
www.crysalli.com
510.732.0100
Connecting the Angle
Stop Adaptor Valve
To tee off an angle stop water valve
that is already being used, locate the
PASVPP9 angle stop adaptor tee. To
connect the angle stop adaptor valve:
1. Shut off water supply at brass/chrome supply valve.
2. Disconnect riser from brass/chrome supply valve.
3. Ensure that the sealing gasket is fully inserted into
the angle stop valve female thread.
4. Install angle stop adaptor valve on supply valve.
5. Connect the riser to the angle stop adaptor valve.
6. Fully insert tubing into the Speedfit side of the valve.
7. Open valves and check for leaks.
For a dedicated angle stop
water valve, use the PSEI6012U9
adaptor fitting.
To use the PSEI6012U9 angle stop adaptor,
identify the angle stop water valve in your
cabinet that will be the water source for the
system, remove the compression nut and ferule
ring from it and thread the PSEI6012U9 fitting
onto the valve where the nut and ferule ring
were, hand tighten the fitting down.
*Conversion adaptor can be threaded to either side of
the valve to make configurations of 1/2”x1/2” NPS or
3/8”x3/8” compression.
1/4 Turn valves. These valves have been
designed to allow temporary servicing of
downstream equipment and must only be used
in the fully open or fully closed position.
DO NOT USE THESE VALVES:
• In a partially open position to control flow.
• To provide a permanent termination.
• Without tubing assembled or plugged (or
threaded connections sealed).
• As a tap or “faucet.”
