CryptoTelecom S-160, Руководство пользователя

Страница: 16 / 86

16
3. Basic Setting
3.1 Check Network and Installation Type
This Chapter is for basic setting of S-160. To install Hardware of S-160, basic understanding of Network is
required. Please refer to Chpater 6 in case knowledge of Network Environment is required. .
There is two ways to install Hardware,
1.
install S-160 without IP sharing Device
under Cable Modem or Leased Line,
2.
install S-160 under IP sharing Device
, which is required under PPPoE environment, and even under
Leased Line or Cable Modem. The default IP Address of S-160 is preset to 192.168.1.8 and Subnet Mask to
255.255.255.0 and Gateway to 192.168.1.1 in ex-factory condition. This explanation is based upon default value
of ex-factory.
Caution 1 : Check Video before installation, on ‘ 2. Installation and Video Check ’.
Caution 2 : In case using IP sharing Device, only Global IP is available.
Caution 3: S-160 does not support PPPoE. IP Sharing Device is required to connect to S-160
under PPPoE.
Installation without IP sharing device
-> For static IP, refer to ‘
Static IP Setup
’.
-> For dynamic IP, refer to ’
Dynamic IP Setup
’.
Installation with IP sharing device
-> Should set up with Static IP. Refer to ‘
Installation with IP Sharing Device ’
.
3.2 Installation without IP sharing device (Router)
3.2.1 Static IP Setup
1) After checking Video in ‘ Video Check ’, go to the next step.
2) Connect S-160 to PC with LAN Cable (Cross Cable).
3)
Cable connection and Network Setup should be same as shown in ‘ 1. Installation and Video
Check ’.
4) Run Web Browser and input 192.168.1.8 in URL and click ‘Enter’, then [Pic. 3-1] will appear.