EB30-2R OPERATING INSTRUCTIONS
Page 12
TEST DESCRIPTION :
Use the following section as a prompt list when performing MOT tests. The next
sections gives a more detailed description and should be studied by new users
before any attempt is made to follow this simple prompt list.
MOT BRAKE TEST PROCEDURE
Note: For Class IV and VII vehicles, use the secondary brake test when checking
the Parking Brake. DO NOT apply the locked parking brake test on these vehicles.
Enter the car details onto the PC (if connected) or press WGHT key to enter car
weight
If the vehicle braking system is fitted with a servo, ensure the engine is running at
idle throughout the test (use exhaust extraction or adequate ventilation).
Before Driving the Vehicle into the Rollers
RESET
the system by pressing
2 nd
and then
STOP,
DDsp shows A1 then Ctr
First Axle
Drive the first axle into the rollers.
Foot Brake
CENTRE THE WHEELS: Press
START
key to start both roller sets, DDsp shows
both rotating icons then Ctr. Allow the wheels to centre and press
STOP
when
alignment is correct . DDsp shows A1.L
AXLE WEIGHT: If weighing is fitted, DDsp will show
U U
while weight is being
measure and then display the axle weight in Tonnes. Note this is necessary and
press OK to proceed.
LEFT FOOT BRAKE:
Press
START
key to start only the left roller set. DDsp
shows left rotating icon then A.1L Apply footbrake smoothly until the wheel stops or
produces its maximum brake effort , then press
STOP.
(This start, test, stop action can be repeated if necessary)
Once acceptable reading has been obtained press
OK
to store the result.
DDsp shows A1.r
