CRT1081IRD-S2-MX
USER’s MANUAL
4.4 ASI output configuration
CRT1081-S2-MX has up to four embedded DVB remultiplexers. Every multiplex bitrate is set
independently on the ASI output configuration page. Set those parameters properly for stable and reliable
device operation.
Рис. 9 Настройка ASI выхода
•
Stream rate
- Let you set bitrate of the selected multiplexer output. 0 kbps means that multiplexer is
inactive.
•
Mode
- You can select byte or packet DVB-ASI operation mode. Reffer to the user’s manual of the
device you fead output TS to.
•
TS ID
– DVB transport stream identifier. It must be unique within your network. 0 to 65535 number
can be set. Leave default if you are not sure what to set;
•
Network ID
– DVB identifier of you broadcast network(0 to 65535). Please reffer to the latest version
of DVB specification ETSI TS 101162 to select correct number;
•
Original Network ID
– DVB identifier the original broadcast network(0 to 65535) the service is taken
from. Please reffer to the latest version of DVB specification ETSI TS 101162 to select correct number.
4.5
DVB-over-IP configuration
4.5.1 Device control IP configuration
Fig. 9 Device IP options page
•
MAC address
– Unique Ethernet network address of CRT1081IRD-S2-MX IPE (1Gbit) port.
•
IP address
– Unique sourcr IP address of the device IPE port;
•
IP encapsulation mode
– Only UDP encapsulation is supported;
•
Status
– Shows the current state of the device DVB-to-IP Encapsulation (1Gbit Ethernet)port.
Note. After reset to the factory settings (4.3.2) your current configuration data will be lost. Export your
Crypton, January 2013
15
