INTERFACING SOLUTIONS
RVCFD-79
REAR-VIEW INTEGRATION INTERFACE
FOR FORD & LINCOLN VEHICLES 2011-UP
W/ MYFORD TOUCH RADIOS
www.cruxinterfacing.com
Rev. 072214
7
CAMERA ACTIVATION AND INSTALLATION
An easy way to test if the Rear-View Camera coding was completed correctly is to place the vehicle into Reverse gear.
Step 9
- With the Rear-View Camera disconnected, Start the vehicle and place the vehicle into the Reverse gear.
The radio display will prompt you with an error message of “Camera Unavailable”. This verifies the coding was a success!
Step 10
- Now you may proceed to installing the Rear-View Camera. Make sure to use the C-125 8-Pin connector for REVERSE and GROUND
for the camera. (See Installation Overview) Note: The vehicle display offers a Zoom + and Zoom - option, this interface does not
support this option.
54-PIN
(female plug)
TO FACTORY
DISPLAY
------------------
------------------
------------------
54-PIN
(male plug)
8-PIN
(male plug)
WHITE/ NOT USED
4 5 6
ON
1 2 3
4 5 6
ON
1 2 3
C-500
INTERFACE
C-125
INTERFACE
DOES NOT REQUIRE YOU TO
TAP FOR REVERSE SIGNAL
(SIGNAL IS FROM MODULE)
SONY
8” RADIO
WHITE/ REVERSE
12V OUTPUT
CAMERA
NOT INCLUDED
TAP GROUND
ON BLACK WIRE OF
8-PIN CONNECTOR
YELLOW/ VIDEO SIGNAL
STATUS LED’S
STATUS LED’S
8-PIN
(male plug)
CAMERA INPUT
BLACK WIRE/ TAP HERE
OPTIONAL/
TOGGLE SWITCH
ENABLE
DISABLE
GREEN/ VIM
GREEN/ VIM
RED WIRE/ TAP HERE
4 5 6
ON
1 2 3
4 5 6
ON
1 2 3
DIP 1 = OFF
2 = ON
3
4
5
DIP 6 = ON
OFF
FACTORY
GPS
DIP 1
2
3
4
5
DIP 6 = ON
OFF
DIP 1 = ON
2 = ON
3
4
5
DIP 6 = ON
OFF
NO
FACTORY
GPS
DIP 1 = ON
2
3
4
5
DIP 6 = ON
OFF
C-500
INTERFACE
C-125
INTERFACE
WIRES FROM CAMERA