G T X 4 6 0 0 - G T X 4 8 0 0
2 6
INTERCONNECTION EXAMPLE 2-Channel Mode: 2 x Mono Subwoofer bridged
Do not connect loudspeaker cables with the vehicle’s chassis.
Always ensure the correct polarity of all connections.
REFERENCE NOTE
Use the bass enhancement with care.
A high bass boost may cause damage to your speakers and hearing abilities.
INTERCONNECTION
• Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT CH 1 and CH 2 of the amplifier with appropriate high-value
RCA cables. If a separate SUB OUT from your headunit is available, use this as LINE OUT.
• Connect the subwoofers with the SPEAKER OUTPUTS CH1/2 + BRIDGED - and CH3/4 + BRIDGED -.
• Ensure by any means, that the total impedance load of all subwoofers per channelpair is not lower than 4 ohms. Too low impedance
cause high temperature and will shut down the amplifier operation.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
INPUT MODE SWITCH
• Select the
2CH
position on the
INPUT MODE
switch.
CROSSOVER SETTINGS & BASS BOOST CONTROLLER
• The X-OVER switch
must
be in position LP/BP and the TWIN SUB switch in position
ON
.
All filter controllers (BASS BOOST, HIGH PASS, LOW PASS, LEVEL) of CH 1/2 are without function in TWIN SUB mode.
LEVEL INPUT CONTROLLER CH3/4 (SUBWOOFER 1+2)
• Attend the regarding notes on page 23.
• All
LEVEL INPUT CONTROLLERS
of CH1/2 are without function.
TWIN SUB & BASS REMOTE CH1/2 (SUBWOOFER 1) & CH3/4 (SUBWOOFER 2)
• The enclosed
BASS REMOTE
controller adjusts the bass-level e.g. from the driver’s seat.
That this
BASS REMOTE
controller is effective on both channel pairs (CH1/2 & CH3/4) you
MUST
set
TWIN SUB
switch in
position
ON
. Please use only the enclosed bass remote controller and cable.
• Is the
TWIN SUB
switch on position
ON
, the controllers BASS BOOST, HIGH PASS, LOW PASS, LEVEL on CH1/2 are without function.
All settings will be synchronized with CH3/4. In switch position
OFF
, the bass remote works only on CH3/4.
Connect Stereo RCA output (L/R or SUB OUT)
of the headunit with the LINE INPUT L/R of the amplifier
Subwoofer 2
4 – 8 Ohms
Subwoofer 1
4 – 8 Ohms
R
L
Switch position CH3/4 = LP/BP
TWIN SUB = ON
Connect the bass remote
controller and the
remote terminal on the amplifier
with the enclosed cable.
INPUT MODE = 2 CH
