Installing the Fin
It is easiest to install the center fin when your board is
deflated. Simply fold the tail end of the board over so that
the fin box is showing completely. Slide the base of the fin
into the track (see picture) and position to the back of the
box. Brand new fin boxes are often a bit tight and may
require a “see-saw” motion to properly insert the fin. En-
sure that you are lining the two pins on either side of the
base of the fin up with the track inside of the fin box. After
a few uses, the fin box will be much easier to insert and
remove the fin. Take the finger screw (no tools necessary)
and unscrew from the front
of the fin. Insert the square
nut into the other end of the
fin track and push forward
using the screw to guide it. Align the nut with the hole in the front of the fin and
tighten the finger screw into place. Once you cannot slide the fin forward or
backwards it is secure and ready.
Deflating Your Stand Up Paddle Board
Untwist the valve cap and make sure to clear away any water or debris. Push
the center pin in to initiate deflation. Be warned, a burst of air will come out
very quickly and may frighten you but this is normal and will calm down
quickly. Once the air has slowed down from the initial burst twist the center pin
in a clockwise motion until it stays in the “down” position. The board will now
deflate without having to hold the pin in.
Folding Up Your
Stand Up Paddle Board
Once you have the center pin of the valve in the “down”
position and air is able to deflate without holding pin in you
may start to fold you board. Start at the nose end of the
board to push the air towards the valve and out. Fold the
board over itself in roughly
1 foot segments until you
reach the tail and all of the air
has been released. Use the
provided clip strap to wrap
around the board for easier
carrying. Place the folded
board along with all of the
provided accessories into the
travel bag and you are all set
to go.
Содержание Voyager AIR 11’6”
Страница 1: ......
