MIR 035 R02
1
Images for reference only.
1.
Assemble the Hang ‘N’ Lock bracket sections making sure all parts
are slotted tightly together.
2.
Place the assembled Hang ‘N’ Lock bracket onto the support slot
on the back of the mirror and hold in place. Measure the distance
from the bottom edge of the bracket to the top edge of the mirror
glass. Make a note of the ‘Bracket Distance’ as it will help you when
mounting your mirror.
Carefully hold your mirror in the desired location on the wall and
using a pencil draw a reference line along the top edge of the mirror.
Use the Bracket Distance you measured earlier to create a reference
line where the bottom of your Hang ‘N’ Lock bracket will be located.
Mounting using Hang ‘N’ Lock
Fig 1
Fixing Pack Contents
Hang’N’Lock Wall Mounting Bracket Kit x1, ‘L’ Shape Bracket Mounting Kit x1.
Tools Required
Drill; 8mm masonry drill bit (8mm ceramic drill bit optional); Cross head screwdriver; Flat head
screwdriver; Pencil; Spirit level
KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN
Home Safety Advice
It is recommended that two people fit the mirror to ensure that it is fitted safely.
Always take care when using an electric drill, particularly in the bathroom. Always check for hidden
cables and pipe work before drilling and take extreme care if there is any water in the working area.
It is advisable to use a residual current circuit breaker (RCCB).
Always wear suitable eye protection when drilling.
If the mirror is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used. Always ensure
that the drill hole passes through the central tiled area rather than through the grouted area. To
prevent unnecessary damage to the tile, mask the area around the hole with tape before drilling.
Do not strike the mirror with hard or sharp
objects.
Fixing Instructions
1. The mirror is rated IP44 and must only be
installed with the connection to the domestic
mains electrical supply in the Outside Zones, as
shown in Figure 1.
2. Ensure that the access to the domestic mains
electrical supply is located behind the intended
mounting position for the mirror and unobstructed
by the mounting brackets.
