Crown CTs 4200, Руководство по эксплуатации, Страница: 11 / 32

CTs
Power Amplifiers
page 11
CTs Power Amplifiers
Operation Manual
4. WARNING: Never connect the output
to a power supply, battery or power
main. Electrical shock may result.
5. Tampering with the circuitry, or making
unauthorized circuit changes may be
hazard ous and invalidates all agency listings,
and may also void the product’s warranty.
6. Do not operate the amplifier with the red Clip
LEDs constantly flashing.
7. Do not overdrive the mixer, which will cause
clipped signal to be sent to the amplifier. Such
signals will be reproduced with extreme
accuracy, and loudspeaker damage may result.
8. Use caution when operating the amplifier with
a 2-ohm load impedance on 1 channel. Do not
operate the amplifier with less than a 2-ohm
load impedance per channel when driving
more than 1 channel. Due to the amplifier’s
output protection, such a config uration may
result in premature clipping, speaker damage
or a blown power fuse.
Remember: Crown is not liable for damage that
results from overdriving other system compo nents.
4.1 Precautions
Your amplifier is protected from internal and
external faults, but you should still take the
fol lowing precautions for optimum performance
and safety:
1. Before use, your amplifier first must be
con figured for proper operation, including
input and output wiring hookup. Improper
wiring can result in serious operating
difficulties. For information on wiring and
configuration, please consult the Setup
section of this manual or, for advanced setup
techniques, consult Crown’s Amplifier
Application Guide available online at www.
crownaudio.com.
2. Use care when making connections, select ing
signal sources and controlling the out put
level. The load you save may be your own!
3. Do not short the ground lead of an output
cable to the input signal ground. This may
form a ground loop and cause oscillations.
4 Operation