- 4 -
PROGRAM OF TRANSMITTERS
a.
Turn ignition on and open a door first and then press Valet/Override switch 4 times (within 15
seconds), then LED will be on continuously and siren will emit 1 long chirp. You are now in the
stage of programming mode.
b.
Press # 1 button then siren will emit 2 short chirps 4 times.
c.
Turn ignition off. LED will be off and siren will emit 4 chirps. You are now in stage of exiting
programming mode.
d.
You can repeat this and have maximum 4 programmed transmitters per module. If you program
new transmitter, we recommend to delete old code memory and to re-program all existing
transmitters. You can have this job up to 4 times by same way above.
ACTIVATION OF ARMING
a.
Exit the vehicle and close all entrances.
b.
Press # 1 button at once.
c.
Siren chirps 1 time, light flashes 1 time and LED flashes slowly every sec.
d.
All protected entrances are armed.
e.
Starter kill enable
Æ
Starter disables relay which is activated and prevents the engine cranking.
f.
If any entrance is opened, siren chirps 3 times and LED flashes rapidly for notification. When
door is closed, the arming will start.
g.
After 3 seconds of arming, alarm system will be activated. Shock sensor will not be activated
during 3 seconds. It will be re-activated in more than 3 seconds and the sensor becomes stable.
ACTIVATION OF DISARMING
a.
Press #2 button at once.
b.
Siren chirps 2 times, light flashes 2 times and LED off.
c.
All protected securities will be disarmed.
d.
Starter kill disable
Æ
Start motor can be enabled
e.
Memory of intrusion: If siren chirps and light flashes
4
times when you disarm the alarm, this
notifies alarm has been triggered. Rapid LED flash every 2 times notifies electric security has been
triggered, while every 3 times LED flash notifies door had been triggered.
MUTE ARMING/ DISARMING
a.
Press # 3 one time, then press # 1 one time within 3 seconds to enter Mute Arming.
b.
Press # 3 one time, then press # 2 one time within 3 seconds to enter Mute disarming
DEACTIVATION OF EMERGENCY
If transmitter is lost or damaged when alarm system is activated arming,
following process is needed .
Æ
Enter Valet Mode first
A CC
IG
OFF
STA R T
VALET SW -8-TI MES
O pen a Door
