1. INTRODUCTION
A. PURPOSE:
This Crown Installation, Operation,
Maintenance and Parts Manual has been developed to
assist you in the installation, operation and maintenance
of your electric operator and thus enable you to utilize it
to its maximum efficiency.
B. MODELS COVERED:
The manual covers current
models 1502-1 & 1502-2 Operators.
C. APPLICATION:
The Crown Industrial Model #1502
Swing Door Operators are intended for use on large
interior industrial doors operated by trained personnel.
D. DESCRIPTION:
The model 1502 operator consists of a 90 volt, DC
permanent magnet gear motor, variable torque electric
clutch, right angle worm gear and internal limit switches.
The motor control is accomplished by means of an
electronic control package. The motor controls are
mounted in a remotely located control panel. The
operator shall mount above the door on the lintel of the
frame. Door connecting arms and door brackets are
included. The operator mounting frame and cover shall
be prime coated ready for finish painting in the field. The
supply voltage should be 120 volt AC, single phase. The
control circuit will allow for two speed operation with the
run and creep speeds independently adjustable.
Figure 1. 1502 Left Hand Swing Door
Operator
2. INSTALLATION AND OPERATION
A. GENERAL
The Crown 1502 Electric Door Operator has been
designed primarily for commercial and industrial
installations where the operator has to withstand
constant hard use. To ensure correct installation
and proper operation of the operator and associated
hardware, the following instructions are given:
(1) SHIPMENT CHECK: Included with the installation
packet is a copy of the packing slip for the components
supplied with the order. Compare the components
received with the packing slip to insure that all
equipment is complete.
(2) REVIEW INSTALLATION DRAWINGS: The
installation drawings show the layout of the door,
template drilling for the door and jamb, and general
terms used to describe the components. Review the
drawings to familiarize yourself with the equipment.
(3) CHECK THE DOORS: Prior to installing the
operator, confirm the doors are properly hung. 95% of
all door operator trouble is caused by doors not swinging
free of the floor and lintel. It is also very important that
all hinge pins are properly aligned and there is no hinge
binding.
(4) PREPARING THE DOOR AND LINTEL:
The door operators are handed (left and right) and
are supplied as push or pull to open (Refer to Figure 2
Operator Handing). Ensure proper backing and support
are available in the lintel and the door to receive the
operator and connecting arm. Remove the electric
operator from crate. Choose the appropriate drilling
template. Prepare the lintel for the operator.
Figure 2. Operator Handing
RIGHT HAND PULL TO OPEN
#1502 OPERATOR
#1502 OPERATOR
LEFT HAND PULL TO OPEN
HINGE
#1502 OPERATOR
#1502 OPERATOR
RIGHT HAND PUSH TO OPEN
LEFT HAND PUSH TO OPEN
HINGE
Crown Industrial Operators • 213 Michelle Ct. • So. San Francisco, Ca 94080-6202
Phone: (650) 952-5150 • Fax: (650) 873-1495
www.crown-industrial.com Email: [email protected]
G-1001
1
Crown Industrial Operators • 213 Michelle Ct. • So. San Francisco, Ca 94080-6202
Phone: (650) 952-5150 • Fax: (650) 873-1495
www.crown-industrial.com Email: [email protected]
Crown Industrial Operators • 213 Michelle Ct. • So. San Francisco, Ca 94080-6202
Phone: (650) 952-5150 • Fax: (650) 873-1495
www.crown-industrial.com Email: [email protected]
