Crown Boiler 24-03, Руководство по установке

Страница: 74 / 90

74
A3. 3-way RTC in Primary/Secondary – Heating and DHW using Indirect W
ater Heater; with/without Outdoor Reset
(MECHANICAL)
NOTES:
1)
Install the boiler as indicated above for systems where return temperatures may be less than 135F and heating/DHW with an indirect water heater
.
2)
The Outdoor Sensor (S3) and the Mix Supply Sensor (S2) are required when the Outdoor Reset feature is selected.
The mix sensor must be installed 10
pipe diameters downstream of the system pump, in the primary loop.
The mix sensor must be secured to the surface of the pipe using a wire tie or similar
device.
3)
The by-pass piping, diverting valve and boiler circulator must be sized using the sizing charts found in
Appendix B.
4)
Closely spaced tees must connect the branch to the larger header
.
The
Tee centerlines must be no greater than 4 times the larger header pipe diameter
.
5)
The diverting valve, V1, must be no greater than 1
1 linear feet of pipe from the Return Sensor
, S1.
6)
There shall be a
MINIMUM
of 4 linear feet of pipe between the By-pass Mix Point, M1, and the Return Sensor
, S1.
7)
The balancing valve in the boiler return line, V2, may be necessary in low head by-pass loop applications.
8)
The indirect heater aquastat (A1) is a normally closed switch. Circuit breaks on temperature rise.
9)
Expansion tanks, air scoops and other components left out for clarity
.
10)
Observe all applicable plumbing and electrical codes.
This diagram is for reference only
. The installer or designer is responsible for the proper selection and design of the
system.