13
Arming the System with a code
Before leaving the premises you must arm the system.
Arming the alarm system turns on all detectors in the partition/s being armed. Be aware that
partitions without assigned zones will not be armed.
1. Enter your
code
.
2. Press
<ENTER>
to arm the system.
NOTE 3
: a voice announcement will be heard at the start of arming procedure to inform
which partition has been armed, and there is an exit delay prior to the system being armed.
During this delay time, a slow beeping is heard to indicate that the system is not armed yet
and reminds you to vacate the protected area.
The symbols
and
light up to indicate that the system is armed.
See next picture
.
To disarm the system during the exit delay, enter your code again and enter or click on
.
ARMED State Symbols
Quick Arm (If enabled at installation by the installer)
This arming procedure is based on the assumption that quick arming has been programmed and
enabled by the installer.
Installer is able to program A or B or C or D keys as quick arm button for user use. (For details
and programming ask your installer)
For instance: A key has been programmed as a quick arm button
Press <
A
> key to arm the system.
As for the Arming indication, refer to NOTE 3 on previous page
